Whole-Home vs. Partial-Home Heat Pump Rebates: Which One Fits Your House?
Mass Save offers two main heat pump rebates for heat pump installations, and the one you qualify for can swing your rebate by thousands of dollars. Whole-home pays more, but asks more of you and your house. Partial-home pays less, but lets you keep your existing boiler or furnace as backup.
We sit down at kitchen tables all over Massachusetts walking homeowners through this exact decision. The right answer depends on how your house is built, how it is heated today, and how comfortable you are letting go of the old system. Below we break down both rebates in plain English, then walk through three real setups we see every week: a cape with oil heat, a colonial with ducts, and a split-level with electric baseboard.
Table of Contents
ToggleWhole-Home vs. Partial-Home at a Glance
The short version: whole-home means the heat pump does all the heating and cooling and the old system is retired. Partial-home means the heat pump does most of the work while your old boiler or furnace stays as backup.
| Whole-home | Partial-home | |
|---|---|---|
| 2026 rebate | $2,650/ton, up to $8,500 | $1,125/ton, up to $8,500 |
| 2027 rebate (installed on or after Jan 1) | $2,350/ton, up to $7,500 | $1,000/ton, up to $7,500 |
| Old heating system | Removed or disconnected | Stays as backup |
| Integrated controls | Not needed | Required on any zone that keeps oil, propane, or gas |
| Weatherization | Required before install | Optional, earns a $500 bonus |
| Extra bonuses | None | Up to $1,000 (sizing and weatherization) |
What whole-home requires
The heat pump has to be your home’s only source of heating and cooling, and the old system has to be removed or disconnected using one of the methods on Mass Save’s Whole-Home Heat Pump Verification Form. The home also has to be weatherized. You meet that rule if your house was built in 2000 or later, if a Home Energy Assessment recommends less than $1,000 in weatherization, or if you have completed the weatherization recommended to you since 2013. If your home does not meet the weatherization rule, you can still get partial-home rebate amounts.
What partial-home requires
Your existing boiler or furnace stays in place to back up the heat pump. If a heating zone keeps oil, propane, or natural gas, you need an integrated control on that zone. That is a smart control that automatically switches to the backup system when it gets too cold outside for the heat pump to run efficiently. If the heat pump fully takes over a zone, the old fuel source for that zone has to be removed or disconnected instead.
Partial-home also offers two $500 bonuses. One is for sizing the system to cover 90 to 120 percent of your whole home’s heating load, backed by a Manual J load calculation. The other is for completing a Home Energy Assessment and the recommended weatherization within a year before or six months after the install.
A few rules that apply to both
Your installer has to be in the Mass Save Heat Pump Installer Network, and the equipment has to be ENERGY STAR Cold Climate certified and on the Mass Save qualified products list. Replacing an old heat pump with a new one does not qualify for either rebate, and neither do heat pumps in new additions or spaces that were never heated. Those situations fall under Mass Save’s smaller basic rebate instead. Income-qualified households heating with oil, propane, or electric resistance can get enhanced rebates of up to $16,000, or a no-cost install in some cases.
Real Setup #1: The Cape with Oil Heat
The house: A 1950s cape, about 1,600 square feet. Oil boiler in the basement, baseboard hot water upstairs and down, no ductwork. The upstairs bedrooms under the knee walls run cold in winter and hot in summer.
This is one of the most common homes we see from Braintree to Marlborough, and it is a great heat pump candidate. Ductless mini-splits are the natural fit since there are no ducts to work with.
The whole-home path: We put a ductless head in each main living area and bedroom, size the system to carry the whole house, and the oil boiler comes out. On a typical 3-ton system, that is a $7,950 rebate for a 2026 install or $7,050 in 2027.
Two things to watch. First, a lot of older capes have never had their attic or knee walls insulated, so a Home Energy Assessment will often recommend more than $1,000 in weatherization. You would need to get that done before the install to qualify for whole-home. The good news is that the weatherization itself is heavily discounted through Mass Save and makes a heat pump work much better. Second, many oil boilers also make your hot water. If the boiler goes, you will need a new water heater, and a heat pump water heater has its own Mass Save rebate.
The partial-home path: If you are not ready to say goodbye to the boiler, we can put mini-splits on the first floor and upstairs, keep the boiler as backup, and add an integrated control so it only kicks on in the coldest weather. A 2-ton partial system earns $2,250 in 2026 or $2,000 in 2027, plus a $500 bonus if you complete the recommended weatherization.
Our take: If you are willing to weatherize, whole-home almost always makes more sense for an oil-heated cape. You get the bigger rebate, stop buying oil entirely, and finally fix those cold upstairs bedrooms. Partial-home is a solid choice if the boiler is fairly new or you want the peace of mind of a backup.
Real Setup #2: The Colonial with Ducts
The house: A 1990s colonial, about 2,600 square feet. Forced hot air from a furnace in the basement, central AC, and ductwork serving both floors. The AC condenser is getting close to the end of its life.
This is the easiest heat pump conversion there is. Because the ducts are already in place, we can usually swap the old AC condenser for a heat pump and replace or adapt the indoor air handler in a single day. Before we quote it, we check that the existing ducts are sized and sealed well enough to deliver heat pump air comfortably, since heat pumps move air at a lower temperature than a furnace.
The whole-home path: The ducted heat pump is sized to heat and cool the whole house, and the furnace is removed or disconnected. A house this size often needs about a 4-ton system, which hits the cap: $8,500 in 2026 or $7,500 in 2027.
The partial-home path: Many colonial owners choose a dual-fuel setup. The heat pump handles heating most of the winter, and the existing furnace stays connected through an integrated control to take over on the coldest days. On a 4-ton system, that is $4,500 in 2026 or $4,000 in 2027. Add up to $1,000 more if you qualify for both the sizing and weatherization bonuses.
Our take: If your furnace is old and your house is reasonably tight, whole-home gets you nearly double the rebate. If your furnace is only a few years old, a dual-fuel partial-home setup lets you get the rest of its life out of it.
Real Setup #3: The Split-Level with Electric Baseboard
The house: A 1970s split-level, about 1,800 square feet, heated entirely with electric baseboard. Window AC units in the summer. The winter electric bills are painful.
Of all three homes, this is the one where a heat pump makes the biggest difference on your bills. Electric baseboard is the most expensive way to heat a Massachusetts home, and a cold-climate heat pump delivers the same heat using a fraction of the electricity. You also get real central cooling and can ditch the window units.
The whole-home path: We usually do ductless heads across the levels, or a mix of ductless and a small ducted unit if there is room for it. The baseboard gets disconnected at the electrical panel, which is one of the approved methods on Mass Save’s verification form. On a 3-ton system, that is $7,950 in 2026 or $7,050 in 2027. Like any older home, it needs to meet the weatherization rule first.
The partial-home path: Some homeowners want to keep baseboard in a rarely used room or two as backup. Since baseboard is electric, there is no integrated control requirement, but the rebate drops to the partial-home rate: a 3-ton system earns $3,375 in 2026 or $3,000 in 2027, plus any bonuses you qualify for.
Our take: For a baseboard home, we almost always recommend whole-home. The rebate is more than double, and since you are replacing electric heat with much more efficient electric heat, there is no fuel to keep around as backup anyway. Baseboard homes are also eligible for income-based enhanced rebates if your household qualifies.
How to Decide Which Rebate Is Right for You
Whole-home is usually the better fit if your current heating system is old or expensive to run, your home is already weatherized or you are willing to do it, and you are comfortable relying on a heat pump alone. Today’s cold-climate heat pumps are built for New England winters, and with proper sizing they keep up just fine.
Partial-home is usually the better fit if your boiler or furnace still has plenty of life left, your home cannot meet the weatherization rule right now, or you simply want a backup system for the coldest nights.
Either way, timing matters. Systems installed by December 31, 2026 get the higher 2026 rebate amounts, and everything installed on or after January 1, 2027 drops to the lower rates.
Get a straight answer for your house
Every home is different, and the best way to know which rebate you qualify for is to have someone actually look at it. Endless Energy is a Mass Save Home Performance Contractor with more than 40 years in the business, 80+ in-house technicians, and offices in Marlborough, Needham, and Randolph. We will do a proper load calculation, tell you exactly which rebate fits your home, and give you a flat-rate price with no surprises.
Book your free heat pump consultation and find out whether whole-home or partial-home makes more sense for your house.
Frequently Asked Questions
What is the difference between whole-home and partial-home heat pump rebates?
Whole-home rebates are for homes where the heat pump becomes the only source of heating and cooling and the old system is removed or disconnected. Partial-home rebates are for homes that keep an existing boiler or furnace as backup. Whole-home pays $2,650 per ton up to $8,500 in 2026, while partial-home pays $1,125 per ton up to $8,500.
Can I keep my boiler or furnace as backup and still get a whole-home rebate?
No. To qualify for whole-home, the old heating system has to be removed or disconnected. If you want to keep it as backup, you would qualify for the partial-home rebate instead.
Do I need integrated controls for a partial-home rebate?
Only if a heating zone keeps oil, propane, or natural gas. The integrated control automatically switches to your backup system when it gets too cold for the heat pump to run efficiently. Electric baseboard backup does not need one.
What if my home doesn’t meet the weatherization requirement?
You can still get a heat pump rebate at the partial-home rate. To qualify for whole-home, complete the weatherization recommended in your Home Energy Assessment before the install.
How much are whole-home and partial-home rebates in 2027?
For systems installed on or after January 1, 2027, whole-home drops to $2,350 per ton up to $7,500, and partial-home drops to $1,000 per ton up to $7,500.
Can I get a rebate for a heat pump in a new addition?
Not a whole-home or partial-home rebate. Heat pumps in new additions or previously unheated spaces fall under Mass Save’s smaller basic heat pump rebate.